That you
Armand you touch me right in the middle
There is a more importante collaboration with Oufti.
The Oufti Song 3.
When i worked on the first oufti song, that was very hard to make the curve because i haven't got any tool only dremel and very little belt sander. Lucas is a very nice guy and make a set of handle with his design and sent it to me some time after i finished my first one oufti song. I take the time to make me a blade for those handle .
95 g
Open 17 cm
Closed 10,5 cm
Thickness 1,2cm to the pivot
Handle XC 75 4 mm.
Blade 9 cm 7 cm useful, 3,2 mm thick d'O2 selective hardening, (the hamon is not nice i polished everything and have to make a little more)
Spacer in galvanised steel, latchless (that one is for me i will carry it without latch ou i will made a little kydex sheath).
SS rasor blade washer...
You can see my finger is band. That is a rasor blade that go away of his place during the increasement of the diameter hole... The blade hit my finger and cut me deeply, but the cut is really clean, that will be cicatrise fastly.
The two no twin brother
Thanks for looking .
Oufti Song 3
Moderator: The Motley Crew
Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
- cardoso5fr
- Posts: 1140
- Joined: Fri Jun 02, 2006 1:30 pm
- Contact: