Hi guys,
After spending much time fabricating them, my new N/S bolsters are ready to be installed. I just want to know if there is anything that needs to be done to them before putting them on the knife, i.e. heat treating? annealing? or anything like that...
Thanks in advance, Dave
Nickel Silver bolsters
Moderators: Bill DeShivs, The Motley Crew
Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
-
- Posts: 65
- Joined: Sun Dec 07, 2003 12:27 am
- Location: Proudly Canadian
- Bill DeShivs
- Yes.
- Posts: 7362
- Joined: Sat May 25, 2002 2:50 pm
- Location: In de lan o' cotton
- Contact:
-
- Posts: 65
- Joined: Sun Dec 07, 2003 12:27 am
- Location: Proudly Canadian
- Bill DeShivs
- Yes.
- Posts: 7362
- Joined: Sat May 25, 2002 2:50 pm
- Location: In de lan o' cotton
- Contact: