Got a 33Cm swinguard the other day, the guards have become a lot more lose than they should be.
Any tips for peening them?
It's proving a lot more difficult than with a brass pin.
Please and thank you
Peening a steel swingaurd pin.
Moderators: Bill DeShivs, The Motley Crew
Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
- Bill DeShivs
- Yes.
- Posts: 7362
- Joined: Sat May 25, 2002 2:50 pm
- Location: In de lan o' cotton
- Contact:
Re: Peening a steel swingaurd pin.
Small hammer, sufficient anvil. Sharp taps.
Bill DeShivs, Master Cutler
http://www.billdeshivs.com
Factory authorized repairs for:
Latama, Mauro Mario, LePre, Colonial, Kabar, Flylock, Schrade Cut Co., Presto, Press Button, Hubertus, Grafrath, Kuno Ritter knives, Puma, Burrell Cutlery.
http://www.billdeshivs.com
Factory authorized repairs for:
Latama, Mauro Mario, LePre, Colonial, Kabar, Flylock, Schrade Cut Co., Presto, Press Button, Hubertus, Grafrath, Kuno Ritter knives, Puma, Burrell Cutlery.
Re: Peening a steel swingaurd pin.
Did your procedure with a small swinger. 2oz. Hammer, taped off bolster just in case. Worked like a charm. Couple of taps and check it. Thanks.