Mr. Bill, two questions for you.

A growing number of collectors customize their automatic knives by changing scales, bolsters, blades, doing fileworks, ... Wether you're a guru or just a wannabe knife modder, this is the place to discuss it!

Moderators: Bill DeShivs, The Motley Crew

Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
kugr
Posts: 169
Joined: Tue Dec 18, 2018 6:55 am
Location: Texas

Mr. Bill, two questions for you.

Postby kugr » Tue Feb 12, 2019 3:46 am

After reading up on your other forum, the knife101 one, I read that you suggested having a stock pile of nickel silver rods. My question is this, is the NS rod ever used as a pivot?

Second question, what can be done about a weak spring? Is there a correct procedure for putting a bit more bend in the curve? Better yet, can it be done without disassembling the knife?

User avatar
Bill DeShivs
Yes.
Posts: 5784
Joined: Sat May 25, 2002 2:50 pm
Location: In de lan o' cotton
Contact:

Re: Mr. Bill, two questions for you.

Postby Bill DeShivs » Tue Feb 12, 2019 4:09 am

In restoration work, nickel silver is seldom used for pivots. In custom work, it can be used as a pivot.

Bending springs is iffy. Whether the can be successfully bent depends on many factors. If the spring can be bent at the proper spot, and bent just enough to surpass it's elastic limit in that spot, the technique works. On modern Italian stilettos, the spring can be bent near the tip a small amount.
You can make a tool with a 1/4" long slot to bend the spring tip.
Bill DeShivs, Master Cutler
http://www.billdeshivs.com
Factory authorized repairs for:
Latama, Mauro Mario, LePre, Colonial, Kabar, Flylock, Schrade Cut Co., Presto, Press Button, Hubertus, Grafrath, Kuno Ritter knives.


Return to “Deforum with Bill DeShivs”

Who is online

Users browsing this forum: No registered users and 4 guests