I'm about ready to make an order to one of the supply houses and I have a material question.
On the list of materials you have .020 or less nickel listed. Is this supposed to be for the
lever spring cover? Also do you happen to have a picture of a "Sigfreid" that is torn
down? I would like to see a pic of all the parts so I can use them as reference.
Thanks
Tim
Bill I have a lesson 2(Knife 101) question.
Moderators: Bill DeShivs, The Motley Crew
Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
- Bill DeShivs
- Yes.
- Posts: 7362
- Joined: Sat May 25, 2002 2:50 pm
- Location: In de lan o' cotton
- Contact:
Re: Bill I have a lesson 2(Knife 101) question.
Gosh-it's been a long time. I think that is for the lever spring cover. Stainless will work, too.
I don't have a picture.
I don't have a picture.
Bill DeShivs, Master Cutler
http://www.billdeshivs.com
Factory authorized repairs for:
Latama, Mauro Mario, LePre, Colonial, Kabar, Flylock, Schrade Cut Co., Presto, Press Button, Hubertus, Grafrath, Kuno Ritter knives, Puma, Burrell Cutlery.
http://www.billdeshivs.com
Factory authorized repairs for:
Latama, Mauro Mario, LePre, Colonial, Kabar, Flylock, Schrade Cut Co., Presto, Press Button, Hubertus, Grafrath, Kuno Ritter knives, Puma, Burrell Cutlery.