Brass Pin Stock Size

This forum is for general discussion regarding anything that cuts.

Moderator: The Motley Crew

Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
Post Reply
XBMX
Posts: 276
Joined: Tue Feb 12, 2019 8:13 pm

Brass Pin Stock Size

Post by XBMX »

Can someone please enlighten me. What are the most common diameters of the Brass Pin Stock used on older German springers. I'm thinking 2.5 and 3mm ??? Thanks
User avatar
Bill DeShivs
Yes.
Posts: 7342
Joined: Sat May 25, 2002 2:50 pm
Location: In de lan o' cotton
Contact:

Re: Brass Pin Stock Size

Post by Bill DeShivs »

2MM and 2.5MM are common, but often smaller sizes were used.
Bill DeShivs, Master Cutler
http://www.billdeshivs.com
Factory authorized repairs for:
Latama, Mauro Mario, LePre, Colonial, Kabar, Flylock, Schrade Cut Co., Presto, Press Button, Hubertus, Grafrath, Kuno Ritter knives, Puma, Burrell Cutlery.
Post Reply