Rivets

skr100 · Post by **skr100** » Thu Jul 11, 2002 11:42 pm

I have a 9" SKM with simulated stag handles. I would like to try and make my own and replace the simulated stag ones. Where can I purchase all the different rivets necessary to reassemble the knife after I completely disassemble it?

The Falcon · Post by **The Falcon** » Fri Jul 12, 2002 3:26 am

Yeah! I'd like to know the answer to that one too. Where do you get the little brass buggers?

Vagrant · Post by **Vagrant** » Fri Jul 12, 2002 8:54 am

I believe the pins are metric sized. Buy the next larger American size at a Hobby Shop if you can't find metric sized ones and have them turned down on a lathe to the metric size.

The Falcon · Post by **The Falcon** » Fri Jul 12, 2002 9:50 am

Vagrant,

There's got to be an easier way. Do you think skm would part with some pins? I guess I could ask 'em.

The Falcon

Post by **arthas** » Fri Jul 12, 2002 12:33 pm

Usually, we do not sell parts. However, if you just need a few for replacement, that will be no problem. Just as support@skm.to.

dexter

Razor_54 · Post by **Razor_54** » Fri Jul 12, 2002 2:19 pm

You can also try http://WWW.TALONMAN1.COM, i have used some of their rivets on american autos. They had the screw type rivets and regular.

Post by **jim d,** » Fri Jul 12, 2002 3:13 pm

skr100,

You could ask Bill at Knife101 over on Delphi

Jim

Greyblade · Post by **Greyblade** » Fri Jul 12, 2002 5:57 pm

Yo skr100,

Try these URLs. I've gotten good service from both of them in the past.

http://www.texasknife.com

http://www.jantzsupply.com

Good luck,
Greyblade