tes the infamous mikov CLONE is back
Moderators: Bill DeShivs, The Motley Crew
Forum rules
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
There are a few things you should know before posting in these forums. If you are a new user, please click here and read carefully. Thanks a lot!
tes the infamous mikov CLONE is back
being that mr. tanto won't sell me scales for my CLONE dualspeed and my edc is gone i got a good suggestion to make scales myself, for it and use it as my edc even if it is a CLONE. question is how? i can grind the old rivits out flush with the bolsters and my dad has an old 2 1/3 ton press and press them out to disassembile the knife. then what? where do i get new rivets and how do i install them. i could press them in as on the cheap knives and file them off . but i want a decent job with the finished top rivets. i've built 11 cars and trucks so im not bad at this stuff. we used ball pean hammers in the old days. can sombody help? P.S. i can tell a suresnap form an imperial, from a hammer brand. etc not good at this new stuff
- hollowdweller
- Posts: 871
- Joined: Fri May 24, 2002 2:36 am
- Location: appalachia
- Bill DeShivs
- Yes.
- Posts: 7378
- Joined: Sat May 25, 2002 2:50 pm
- Location: In de lan o' cotton
- Contact:
Go to http://forums.delphiforums.com/Knife101/messages
Bill DeShivs
Bill DeShivs
- Claudester
- Posts: 2767
- Joined: Mon May 27, 2002 5:54 am
- Location: Out back, Takin a leak
- Contact: